The Bobrick Contura Series presents this remarkable commercial restroom waste bin. It boasts a satin-finish stainless steel body, which not only looks sleek but also offers great durability. With a capacity of 12.75 gallons (48.3-L), it can handle a large amount of waste. The unit measures 15 1/8 inches wide, 23 inches high, and 8 1/2 inches deep (385 x 585 x 215mm). The top edges are hemmed and the bottom of the waste receptacle has a recessed finger grip for safe and easy handling. The receptacle is made of 18-8, type-304, 20-gauge (1.0mm) stainless steel with all-welded construction. Its exposed surfaces have a beautiful satin finish. The front of the waste receptacle has the same arc as other Bobrick Contura Series washroom accessories, and the radius on the side edges complements them. Reinforcement straps on the back provide strength to the four mounting screw holes. Equipped with a LinerMate Trash Liner Holder, it simplifies the installation and removal of disposable trash liners and keeps the liner inside the receptacle. The LinerMate has a molded plastic sleeve with a 20-gauge (1.0mm) stainless steel, U-shaped support strap hemmed for safety and a riveted construction. When properly mounted, the space between the bottom of the waste receptacle and the floor makes floor cleaning easy.
Using the Bobrick B-277 waste bin is a breeze. To insert a disposable trash liner, just lift the LinerMate up and forward and rest it over the edge of the waste receptacle front panel with the bottom notches engaged on the top front edge. Place the trash liner inside the LinerMate and fold it over the sleeve. Tie a knot in the corner of the bag and then put the LinerMate with the liner back into the receptacle. To empty it, gather the liner from the LinerMate sleeve and lift the bag up. When installing, mount the unit on the wall with four sheet - metal screws (not included) at the points marked by an S. For plaster or drywall, use concealed backing to meet local building codes. For other wall surfaces, you can use fiber plugs, expansion shields, 1/8 - inch (3mm) toggle bolts, or expansion bolts. To maintain it, simply wipe the stainless - steel surface regularly with a mild cleaner. Avoid using abrasive materials that could scratch the satin finish. Also, make sure to check the LinerMate regularly for any signs of wear and tear and replace it if necessary.
