Product Detail
The ASI 3550 is a high - quality horizontal grab bar. It has a 1.5 - inch diameter and a sleek smooth finish. Measuring 24 inches by 36 inches, this grab bar is made from 18 - gauge stainless steel tubing. The attractive satin finish not only reduces fingerprints but also gives it a shiny look. At each end and the angle, there are 3 - inch diameter flanges made of type - 304, 11 - gauge stainless steel, herliarc welded securely to the tubing. Each flange has three 7/32 - inch diameter countersunk, predrilled holes. These holes, placed about every 120 degrees, are designed to accept No. 10 self - tapping screws or oval head mounting screws (not included). Once installed, the mounting hardware stays fully exposed. This grab bar meets or exceeds all ADA requirements.
Using the ASI 3550 grab bar is easy. First, gather the necessary No. 10 self - tapping screws or oval head mounting screws. Find a suitable location on the wall where you need support. Line up the flanges of the grab bar with the wall and use the predrilled holes as a guide to mark the spots for screwing. Then, drill holes in the wall and insert the screws to mount the bar securely. Make sure to keep the bar horizontal for the best support. When it comes to maintenance, simply wipe the grab bar with a soft, damp cloth regularly to keep it clean and free from fingerprints. Avoid using abrasive cleaners as they may damage the satin finish. Also, check the screws periodically to ensure they are still tight and the bar remains stable. If you notice any signs of wear or damage, it's a good idea to replace the grab bar to keep it safe for use.
