Product Detail
The ASI 3456 is a top - notch horizontal grab bar. It has a 1 - 1/4 - inch diameter and a sleek, smooth finish. Measuring 54 inches by 36 inches, it's made from 18 - gauge stainless steel tubing with an appealing satin finish. This finish not only reduces fingerprints but also gives it a beautiful shine. At both ends and the angle, there are 3 - inch - diameter flanges. These flanges, crafted from type - 304, 11 - gauge stainless steel, are firmly herliarc welded to the tubing. Inside each flange, there are three 7/32 - inch - diameter countersunk, predrilled holes. Positioned about every 120 degrees, they're designed to fit No. 10 self - tapping or oval head mounting screws (not included). After installation, the mounting hardware stays visible. This grab bar fully meets or even surpasses ADA requirements.
Using this ASI 3456 grab bar is easy. First, gather the necessary mounting screws (not included). Align the flanges of the grab bar with the desired mounting location, making sure the predrilled holes match up. Insert the screws into the holes and tighten them securely. Remember, since the mounting hardware will be exposed, make sure to install it in a place where it won't be easily bumped. As for maintenance, just wipe it down regularly with a soft cloth. Avoid using abrasive cleaners that could scratch the satin finish. If there are fingerprints, a mild soap and water solution can do the trick. Keep it clean to ensure it always looks great and meets safety standards.
