The ASI 3402-52P is a top - notch straight grab bar with a 1 - 1/4 - inch diameter. Thanks to an intermediate support, it's extra strong. Measuring 52 inches long, it has a smooth and sleek finish. Crafted from 18 - gauge stainless steel tubing with an alluring satin finish, it resists fingerprints while shining attractively. There are 3 - inch - diameter flanges at both ends and the center, made of type - 304 stainless steel and herliarc welded to the tubing. Each flange has three 7/32 - inch - diameter countersunk, predrilled holes, designed for No. 10 self - tapping or oval head mounting screws (not included). Holes are spaced about every 120 degrees for a super - secure installation. Once mounted, the hardware is fully exposed. This grab bar meets or exceeds all ADA requirements.
Using this grab bar is easy. First, find a suitable location on the wall. Then, line up the flanges with the wall and use the predrilled holes to install it with the appropriate screws (you'll need to buy them separately). Make sure the holes are spaced about every 120 degrees for a stable setup. When using it, just hold on firmly for support. As for maintenance, a simple wipe with a soft cloth is usually enough to keep its satin finish looking great. Avoid using abrasive cleaners that could scratch the surface. Also, check the screws periodically to ensure they're still tight. If you notice any looseness, tighten the screws right away to keep the grab bar secure.
