The Bradley WBD1 WashBar Duo is a revolutionary one-piece unit that combines touch-free soap dispensing and water flow for a seamless hand-washing experience. With advanced WashBar technology, it intuitively guides users and prevents simultaneous activations. You can choose between foam or liquid soap options, and the unit comes with supply hoses and all necessary soap dispenser components. This single-piece design allows users to access soap and water without leaving the hand-washing station, handling washroom traffic quickly and economically while providing personal space. Load-tested to 500 pounds, it's secured to the basin with two anti-rotational shanks. Blue LED lights guide users to the functions, changing to green when in use, and each function is clearly marked with an icon on the top surface. The sensors have a 1 - 2 second turn-off delay for smooth operation and are not affected by skin tone or darkness. Smart technology makes it easy for facilities managers or maintenance staff to clean and configure. The soap dispenser on the left side eliminates dripping, reducing slip hazards and making cleaning a breeze. It's compatible with most bulk soaps and can accommodate up to a 1-gallon container, reducing the need for frequent replacements. When the LED above the soap function turns solid red, reset the counter and check the soap level. The soap system includes an adapter for common 1-gallon containers. The faucet on the right side has a spray angle of about 17 degrees off the vertical. It comes with a standard PCA silicone tip, non-aerated spray pattern, and a maximum run time of 11 seconds per activation. There's an automatic 5-second purge within 24 hours of last use, and the recommended operating range is 20 - 80 psi. Each WashBar Duo is powered by a 120V 2 A 12V DC adapter that plugs directly into an electrical outlet.
Using the Bradley WBD1 WashBar Duo is a breeze. Just place your hands under the appropriate sensor, and the touch-free technology will dispense soap or water for you. The blue LED lights will guide you to the functions, and they'll turn green when the function is in use. For the soap dispenser, if the LED light above it turns solid red, you need to reset the soap counter. Then, check the soap level in the container. If it's low, simply replace it with a full 1-gallon container using the included adapter. The faucet has a set spray pattern and run time, so you don't have to worry about adjusting it. It'll automatically purge for 5 seconds within 24 hours of last use. When it comes to maintenance, the smart technology allows facilities managers or maintenance staff to clean and configure the unit easily. Make sure to keep the sensors clean for optimal performance. Also, ensure that the power adapter is properly plugged into the electrical outlet. The recommended operating pressure range is 20 - 80 psi, so try to keep it within this range for the best results.
