The ASI 9013 is a high - quality, recessed - mounted baby changing station made of type - 304 stainless steel. It features a welded construction with a satin finish, offering both durability and a sleek look. This station is ADA compliant, ensuring easy access and safety for all users. The changing surface is made of high - impact - resistant plastic, which is FDA - approved, resistant to fungus and bacteria, and incredibly easy to clean. It has an adjustable two - part safety strap suitable for infants up to 3.5 years old and can support up to 50 lbs, while the entire unit can hold up to 400 pounds. With a pull handle and concealed spring, it allows for effortless one - handed operation. The design includes two bag hooks, dispensers for bed liners and paper towels. The recessed design requires a rough opening of 34 - 1/4 inches wide, 22 - 3/4 inches high, and 3 - 3/4 inches deep. It complies with ASTM F - 2285, G - 21, G - 22, and ANSI Z535 and comes with a 5 - year warranty against material or workmanship defects.
Using the ASI 9013 baby changing station is a breeze. To open it, just pull down the changing table with one hand. It's counterbalanced by a damped gas spring, so you can operate it with less than 5 lb sf of force, and you don't need to tightly grasp, pinch, or twist your wrist. Once the table is open, secure your baby in place using the adjustable two - part safety strap. Slide the safety strap into the cam buckle until it fits snugly around your baby, and you can tighten or loosen it by pulling the strap end through the buckle. To unbuckle, simply lift the buckle lever. When it comes to installation, you'll need to create a rough wall opening that's 34 - 1/4 inches wide, 22 - 3/4 inches high, and 3 - 3/4 inches deep. You can mount the unit using either four self - threading screws through the side holes or four lag screws through the mounting holes in the rear wall of the cabinet. Don't forget to use the washers and snap covers provided. Make sure to install it so that the top edge of the changing table is 32 to 32 - 3/8 inches above the finished floor for ADA compliance. For maintenance, since the changing surface is made of high - impact - resistant plastic, you can easily wipe it clean with a mild detergent and water. Regularly check the safety strap and other components for any signs of wear and tear. If you notice any issues, contact the manufacturer as the unit comes with a 5 - year warranty.
